1. 取扱説明書・マニュアル >
2. サムスン >
3. スマホ・携帯電話 >
4. スマートフォン >
5. SC-01C の使い方、故障・トラブル対処法 >
6. SC-01C の取扱説明書・マニュアル

SC-01Cの取扱説明書・マニュアル [全143ページ 7.85MB]

130付録／困ったときには2. Increase the separation between the equipment and receiver.3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.4. Consult the dealer or an experienced radio/TV technician for help.Your device is a radio transmitter and receiver. It is designed and manufactured not to exceed the exposure limits for radiofrequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government.These FCC exposure limits are derived from the recommendations of two expert organizations: the National Council on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and Electronics Engineers (IEEE).In both cases, the recommendations were developed by scientific and engineering experts drawn from industry, government, and academia after extensive reviews of the scientific literature related to the biological effects of RF energy.The exposure limit set by the FCC for wireless devices employs a unit of measurement known as the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of RF energy by the human body expressed in units of watts per kilogram (W/kg). The FCC requires wireless devices to comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg).The FCC exposure limit incorporates a substantial margin of safety to give additional protection to the public and to accou nt for any variations in measurements.SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Although t he SAR is determined at the highest certified power level, the act ual SAR level of the device while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are t o a wireless base station antenna, the lower the power output.Before a new model device is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC. Tests for each model of a device are performed in positions and locations (e.g. near the body) as required by the FCC.For typical operations, this device has been tested and meets FCC RF exposure guidelines.Use of other accessories may not ensure compliance with FCC RF exposure guidelines.The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with th e FCC RF exposure guidelines. The maximum Body-worn SAR value for this model phone as reported to the FCC is 1.29 W/kg.This device meets the FCC Radio Frequency Emission Guidelines.SAR information on this and other model devices can be viewed online at http://ww.fcc.gov/oet/ea. To find information that pertains to this particular model device, this site uses the FC C ID number A3LSWDSC01C.Follow the instructions on the website and it should provide values for typical or maximum SAR for a particular device. Additional product specific SAR information can also be obtaine d at www.fcc.gov/cgb/sar.FCC RF exposure informationFCC Radio Frequency Emission

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.