1. 取扱説明書・マニュアル >
2. カメラ >
3. カメラ本体 >
4. 一眼レフカメラ >
5. 一眼レフカメラ 全般 の使い方、故障・トラブル対処法 >
6. 一眼レフカメラ 全般 の取扱説明書・マニュアル

Leica M7の取扱説明書・マニュアル [全134ページ 1.37MB]

81Film type1Film speed Exposure Viewfinder displays Value usedloaded setting compensation for exposureset first 2s remaining 14s2meteringDX DX No DX value exp. met. display DX valueYes DX value flashes exp. met. display, result. value (DX+lower pt. flashes exp. comp. value)DX No DX value exp. met. display, DX valueYes DX value flashes exp. met. display, result. value (ISO-+ lower pt. flashes exp. comp. value)DX manual, No/Yes DX value flashes3exp. met. display, set / result. valuenot equal to DX valuelower pt. flashes (ISO -+ exp. comp.valuenon-DX manual No set value exp. met. display, set valuelower pt. flashesYes result. value4exp. met. display, result. value (ISO-+lower pt. flashes exp. comp. value)non-DX DX No/Yes "1 0" flashes exp. met. display, ISO 100/result. lower pt. flashes value (100+ exp.comp. valueDX or non-DX incorrect, between Yes/No "A S A" flashes "A S A" flashes ISO 100the sectionsmanual,equal to DX valueThe set, displayed and used film speed 1Non-DX also applies to DX-coded films, for which the camera cannot read theDX identification, e.g. due to damage or soiling.2Different displays at low battery power (see also the section "Automatic battery check” on p. 72 for details).3Does not flash if set ISO-speed plus compensation value equals DX-value.4 High speed values along with the compensations may result in effective ISOvalues greater than 8000 (e.g. ISO 6400/39° + 2/3EV => ISO 10000/41°),i.e. five-digit values, that cannot be shown by the four-digit display. In such cases, the first four digits of the resulting value are shown, with the right ze-ro flashing to show that there is a "missing” zero, e.g. for the above example"1 00”.

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.