PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
PICTURE menuSettingsENGLISH - 31DAYLIGHT VIEWYou can keep the projected image bright and vivid even in well-lit rooms where the ambient light sources cannot be controlled, such as when a door opens or when window coverings fail to block out sunlight.Change settingChange settingAUTO ON OFFAUTOAutomatic adjustmentONActiveOFFDeactiveRemarksDo not cover the Ambient Luminance Sensor ( zALS) of the projector. The AUTO mode may not operate normally.AUTO z is not available when INSTALLATION in PROJECTOR SETUP menu is set to REAR/DESK or REAR/CEILING.STILL MODEYou can reduce the vertical licker when projecting a still image.(Available with signals of S-VIDEO/VIDEO only)Change settingChange settingOFFDeactiveONActiveNoteYou must set to zOFF when projecting a moving image.NOISE REDUCTIONYou can switch the automatic noise reduction system on/off.(Available with signals of S-VIDEO/VIDEO only)Change settingChange settingOFFNo noise reductionONAutomatic noise reductionNoteNOISE REDUCTION z is set active when the selected input signal has less noise. Applying noise reduction may affect the image quality, if so, set to OFF .TV-SYSTEMWhen the video signal is changed, the setting switches automatically. You can switch the setting manually to match the video data.(Available with signals of S-VIDEO/VIDEO only)Change settingChange settingAUTO NTSC NTSC4.43SECAM PAL-N PAL-M PALNoteAUTO z mode is selected by default.When the projector is not working properly in zAUTO mode, change the setting according to each TV system type.RemarksAUTO z setting will automatically select the compatible signal from NTSC/NTSC 4.43/PAL/PAL60/PAL-M/PAL-N/SECAM.RGB/YPBPR AUTO mode is selected by default. If the image is not projected normally in the AUTO mode, select RGB or YPBPR according to the input signal. The function becomes effective only when certain signals below are input. (VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i, 720/60p, 720/50p) Select the signals to be input to the COMPUTER1 and COMPUTER2 IN terminal.Change settingChange settingAUTOAutomatic adjustmentRGBFor RGB signalsYPBPRFor YPBPR signals
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品