PT-LB90NTの取扱説明書・マニュアル [全68ページ 8.58MB]
cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf
gizport - 2013-08-16
http://dl.owneriq.net/.../cb9b3cf2-6572-4b42-97aa-319a89d99e77.pdf - 8.58MB
- キャッシュ
25994view
68page / 8.58MB
Care and ReplacementMaintenance50 - ENGLISHAttach the lamp unit cover and tighten the 2 lamp unit cover ixing screws securely 5 ) with a Phillips-head screwdriver.Connect the power cord to a wall outlet.6 ) Press the POWER button and the projection starts.7 ) RemarksIf zINITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the power cord is connected to a wall outlet. (AEpage 39)Press the MENU button to display the main menu and press▲▼buttons to scroll to 8 ) the PROJECTOR SETUP menu.Press the ENTER button to select the PROJECTOR SETUP menu and 9 ) press▲▼buttons to select LAMP RUNTIME.Press and hold the ENTER button for approximately 3 seconds.10 ) The zLAMP RUNTIME conirmation screen is displayed.LAMP RUNTIMELAMP RUNTIME RESET .OKCANCELPRESS ANY OTHER BUTTONPRESS BUTT ONNoteIf any button other than the zPOWER button is pressed, the LAMP RUNTIME screen disappears and the lamp runtime is not reset. (Repeat from step 8 again).Press the POWER button. 1 ) After the lamp goes off, projection stops and the zPOWER button lights in red, then disconnect the power plug.The lamp runtime is reset to “0”. 12 )
参考になったと評価
12人が参考になったと評価しています。
この取扱説明書が関連付けられている製品