MENTOR MENUETの取扱説明書・マニュアル [全34ページ 2.24MB]
83120.pdf
gizport - 2013-09-25
http://153.127.246.254/.../83120.pdf - 2.24MB
- キャッシュ
13738view
34page / 2.24MB
13UKDEDK3) Power LED LED off: Mains power is Off LED green: Subwoofer is On LED red: Subwoofer is in Stand-by mode4) Auto/manual Flick the switch to the desired position. AutO: Switch up = the subwoofer will automatically power up upon detection of an input signal on the LINE IN inputs. the Subwoofer will power down after approximately 20 minutes with no input signal present on the input connectors. MANuAL: Switch down = Stand-by only possible via the Remote control.5) Left + right line inputs using these inputs activates the built-in crossover and makes crossover Frequency and Phase adjustment possible. use these inputs for the stereo set-up LEFt: connect to the LEFt RcA line output on your stereo/surround (pre-) ampliier. RIGHt: connect to the RIGHt RcA line output on your stereo/surround (pre-) ampliier.6) LFE line input using this input by-passes the built-in crossover. All adjustments must be done from your surround (pre-) ampliier. use this input for surround systems e.g. 5.1 and 7.1. LFE: connect to the LFE RcA line output on your surround (pre-)ampliier.7) ON/OFF switch Switch to turn the subwoofer On/Off from the mains supply.8) Mains fuse - ATTENTION! If the subwoofer does not power up in the ON position, the fuse might be blown. to replace the fuse, unplug the mains cable, open the fuse compartment and replace the fuse with one of the same type .If the fuse blows multiple times, have the subwoofer serviced by qualiied personnel. Please note that the voltage range written below the mains fuse holder must match the voltage of your mains supply. 120V version: use/replace w.t5AL/250V fuse 220-240V version: use/replace w.t2.5AL/250V fuse
参考になったと評価
5人が参考になったと評価しています。
この取扱説明書が関連付けられている製品