GSの取扱説明書・マニュアル [全77ページ 1.93MB]
sec_04_03.pdf
http://drivers.lexus.com/.../sec_04_03.pdf - 1.93MB
- キャッシュ
12466view
77page / 1.93MB
4444-3. Do-it-yourself maintenanceGS_G_U (OM30B43U)March 8, 2010 10:20 amnInitializing the tire pressure warning systemInitialize the tires with the tire inflation pressure adjusted to the specified level.nIf you push the tire pressure warning reset switch accidentallyIf initialization is performed, adjust the tire inflation pressure to the specified level and initialize the system again. nWhen the initialization of the tire pressure warning system has failedInitialization can be completed in a few minutes. However, in the following cases, the settings have not been recorded and the system will not operate properly. If repeated attempts to record tire inflation pressure settings are unsuccessful, have the vehicle inspected by your Lexus dealer.lWhen operating the tire pressure warning reset switch, the tire pressure warn-ing light does not flash 3 times and the setting message does not appear on the multi-information display. lAfter carrying out the initialization procedure, the tire pressure warning light blinks for 1 minute then stays on after driving for 20 minutes.nRoutine tire inflation pressure checksThe tire pressure warning system does not replace routine tire inflation pressure checks. Make sure to check tire inflation pressure as part of your routine of daily vehicle checks.
参考になったと評価
4人が参考になったと評価しています。
その他の取扱説明書
14535 view
1697 view
7235 view
1572 view
870 view
もっと見る