MINIの取扱説明書・マニュアル [全148ページ 3.08MB]
ownersmanual2003.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2003.pdf - 3.08MB
- キャッシュ
27720view
148page / 3.08MB
125OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXJUMP-STARTING Preparing for jump-starting 1. Check whether the battery of the sup-port vehicle has 12 Volts and approxi-mately the same capacity – measured in Ah, printed on the battery2. Switch off the engine of the support vehicle3. Switch off any electrical systems and components in both vehicles – except for the hazard warning flashers of the support vehicle.> Do not disconnect the discharged bat-tery from the vehicle electrical system> Make certain that there is no contact between the bodywork of the two vehicles – short circuit hazard!4. With the battery of the MINI COOPER, remove the cover panel. To do so, press both clips at the same time or with the MINI COOPER S, open the cover of the positive terminal connection for jump-starting*, see arrow 1. Connect the jumper cablesAdhere to the sequence also when providing support for other vehicles; failure to observe this procedure can lead to sparks at the terminals and pose an injury hazard. <1. On the MINI COOPER S, the positive ter-minal connection for jump-starting, see arrow 1, functions as the positive bat-tery terminal.Make a connection with the "+" jumper cable between the positive terminal of the discharged battery and the positive terminal of the support battery2. Use the second, "–" jumper cable to set up the connection between the negative terminals of both vehicles. To do so:> Connect one terminal clamp to the negative terminal and/or to an engine or body ground of the support vehicle> Connect the second terminal clamp to the negative terminal of the battery and/or to an engine or body ground of the vehicle to be started. For the MINI, see arrow 2.Performing the jump-start 1. Start the engine of the vehicle providing the current and allow to run at a fast idle speed for several minutes2. Start the engine on the vehicle with the discharged battery in the usual manner. > If the first start attempt is not suc-cessful, wait a few minutes before another attempt in order to allow the discharged battery to rechargeOn the MINI:Before disconnecting the jumper cables, switch on the lighting, rear window defroster and the highest blower speed as well as the engine for at least approx. 10 seconds to prevent a voltage surge from the regulator to the electrical systems and components. <3. Then disconnect the jumper cables in the reverse order.If necessary have the battery checked and completely charged at a MINI Dealer.ba.book Seite 125 Montag, 5. August 2002 8:09 20
参考になったと評価
7人が参考になったと評価しています。
その他の取扱説明書
31558 view
11433 view
41069 view
3378 view
35309 view
もっと見る