MINIの取扱説明書・マニュアル [全165ページ 2.67MB]
ownersmanual2005.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2005.pdf - 2.67MB
- キャッシュ
36920view
165page / 2.67MB
130MINI MOBILITY SYSTEM*Pumping in liquid sealant 1. Shake the filling canister 2. Screw the filling hose onto the filling canister3. Unscrew the dust protection cap from the valve of the defective tire4. Screw out the valve core with the valve remover. The valve remover is located in a package with the filling hose.Place the valve core and valve remover only on clean surfaces. <5. Remove the cap from the filling hose 6. Push the filling hose onto the tire valve7. Hold the filling canister with the cap down and squeeze. Squeeze the entire contents of the canis-ter into the tire8. Remove filling hose 9. Screw valve core into the tire valve with the valve remover.In the event of a lost or dirty valve core you will find another valve core in a package with the filling hose. Please remember that the liquid canister must be replaced every four years if the equipment has not been used. <Reinflating the tire 1. Screw hose 1 with manometer onto the tire valve2. Connect plug 3 to the cigarette lighter socket in the vehicle interior, refer to page 823. Ignition key in position 1: Turn on compressor 24. Inflate the tires to at least 26 psi /180 kPa, but not to more than 36 psi /250 kPa. To check the current air pressure, shut off the device for a short time.Do not run the compressor for longer than 6 minutes, otherwise the device will overheat and possibly be damaged. <
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
33068 view
11935 view
43011 view
3545 view
28682 view
もっと見る