MINIの取扱説明書・マニュアル [全283ページ 9.38MB]
ownersmanual2012couperoadsterconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2012couperoadsterconvertible.pdf - 9.38MB
- キャッシュ
8456view
283page / 9.38MB
CONTROLS Technology for driving comfort and safety90Resetting the systemReset the system again af ter each correction of the tire inflation pressure and after every tire or wheel change.1."Vehicle Info"2."Vehicle status"3."Reset"4.Start the engine - do not drive away.5.Select "Reset" to start the initialization.6.Start to drive.The tires are shown in gray and "Resetting TPM..." is displayed.After driving a few minutes, the set inflation pressures in the tires are accepted as the target values to be monitored. The resetting process is completed automatically as you drive. The tires are depicted in green on the Control Display and "Status: TPM active" is displayed again.The trip can be interrupted at any time. When driving resumes, resett ing is continued auto-matically.If a flat tire is detected while the system is resetting, all tires on the Control Display are displayed in yellow. The message "Low tire!" is displayed.<Message for low tire inflation pressureThe warning lamps come on in yellow and red. A message appears on the onboard computer. An acoustic signal also sounds.1.Reduce speed and stop the vehicle with caution. Avoid sudden braking and steering maneuvers.2.Check whether the vehicle is equipped with normal tires or with run-flat tires.Run-flat tires, refer to page 218, are identi-fied by a circular sy mbol containing the letters RSC on the tire sidewall.When a low inflation pressure is reported, the Dynamic Stability Cont rol DSC is activated.Actions in the event of a flat tireNormal tires1.Identify the damaged tire.To do so, check the inflation pressure in all four tires. The inflatio n pressure display of the Mobility Kit, refer to page 237, can be used for this.If the inflation pressure is correct in all four tires, then the Tire Pressure Monitor may not have been reset. The system must then be reset.If it is not possible to identify the damaged tire, contact your MINI dealer.2.Use the Mobility Kit to remedy the flat tire on the damaged wheel, refer to page 237, or to replace the damaged wheel, refer to page.239.The use of tire sealant, e.g. Mobility Kit, can damage the TPM wheel electronics. In this case, have the electronics checked and replaced if necessary at your earliest opportunity.Run-flat tiresYou can continue driving with a damaged tire at speeds up to 50 mph/80 km/h.If the vehicle is not equipped with run-flat tires, do not continue driving; continuing to drive can result in serious accidents.<
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
33125 view
11941 view
43055 view
3554 view
28692 view
もっと見る