MINIの取扱説明書・マニュアル [全254ページ 4.62MB]
ownersmanual2012countryman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2012countryman.pdf - 4.62MB
- キャッシュ
69229view
254page / 4.62MB
Replacing components MOBILITY 219Changing wheelsThe pouch with the wheel changing kit is stored under the flat load floor.It includes:>Vehicle jack>Reversible ratchet>Wheel stud wrench>Extractor hook for wheel center cover>ChockPreparing for a wheel changeObserve the safety precautions regarding flat tires on page 216 . <Additional safety measures when chang-ing tires: Only change the tire when parked on a surface that is level, firm and not slippery.The vehicle or the jack could slip sideways on soft or slippery support surfaces, such as snow, ice, flagstones, etc. Do not use a wooden block or similar object as a support base for the jack, as this would prevent it from extending to its full support height and reduce its load-carrying capacity. Do not lie under the vehicle or start the engine when the vehicle is supported by the jack; other-wise, there is a risk of fatal injury. <1. Place the foldable chock behind the front wheel on the other side of the vehicle or in front of the wheel if the vehicle is on an incline. If the wheel is changed on a surface with a more severe slope, take additional precautions to secure the vehicle from roll-ing.2. Uncover the lug bolts if necessary.3. Loosen the lug bolts by a half turn.Jacking up the vehicleThe vehicle jack is designed for changing wheels only. Do not attempt to raise another vehicle model with it or to raise any load of any kind. To do so could cause accidents and personal injury. <1. Place the jack at the jacking point closest to the wheel.The jack base must be perpendicular to the surface beneath the jacking point.2. Slide reversible ratchet onto the fixture on the jack, arrow 1 .3. As you ratchet up the jack, place the jack head onto the lifting point on the body, arrow 2 .4. Jack the vehicle up until the wheel you are changing is raised off the ground.Mounting the wheel1. Unscrew the lug bolts and remove the wheel.2. Remove accumulations of mud or dirt from the mounting surfaces of the wheel and hub. Clean the lug bolts.3. Lift the new wheel into place.4. Screw at least two lug bo lts finger-tight into opposite bolt holes.5. Screw in the remaining bolts.
参考になったと評価
17人が参考になったと評価しています。
その他の取扱説明書
32652 view
11800 view
42538 view
3464 view
28418 view
もっと見る