MINIの取扱説明書・マニュアル [全267ページ 2.77MB]
ownersmanual2013hardtopclubman.pdf
gizport - 2013-09-06
http://libraryofmotoring.info/.../ownersmanual2013hardtopclubman.pdf - 2.77MB
- キャッシュ
49211view
267page / 2.77MB
MOBILITY Replacing components226to about 5 bar/73 psi. Do not switch off the compressor during this phase. <Do not run the comp ressor for longer than 10 minutes; otherwise, the device will overheat and possibly be dam-aged.<8.Switch off the compressor.If an inflation pressure of 1.8 bar/26 psi is not reached:1.Unscrew the filling hose 2 from the wheel and drive the vehicle forward and backward approx. 33 ft/10 m to distribute the liquid sealant in the tire evenly.2.Inflate the tire again with the compressor.If an inflation pressure of 1.8 bar/26 psi is not reached, then the tire is too badly damaged. Please contact the nearest MINI dealer.<Stowing Mobility Kit1.Unscrew filler hose 2 of the sealant bottle from the wheel.2.Unscrew connecting hose of the compressor6 from the sealant bottle.3.Connect the filler hose 2 of the sealant bot-tle to the unoccupied connection on the sealant bottle.This prevents the rest of the sealant from escaping from the bottle.4.Wrap the empty sealant bottle in suitable material to avoid dirt ying the cargo area.5.Stow Mobility Kit back in the vehicle.Distributing the sealant.Immediately drive approx. 3.1 miles/5 km so that the sealant evenly distributes itself.Do not exceed speeds of 50 mph/80 km/h.If possible, do not drop below 10 mph/20 km/h.<Adjusting the tire pressure1.After driving approx. 3.1 miles/5 km or 10 minutes, stop at a suitable location.2.Screw the connection hose 6 of the com-pressor directly onto the tire valve.3.Insert the plug5 into the power socket in the vehicle interior.4.Adjust tire pressure to 1.8 bar/26 psi. With the engine running:>To increase the inflatio n pressure: switch on the compressor. To ch eck the current infla-tion pressure, switch off the compressor.Do not run the compressor for longer than 10 minutes; otherwise, the device will overheat and possibly be dam-aged.<>To decrease the inflat ion pressure: press the release button9.If the tire cannot m aintain the inflation pressure, drive the vehicle again, refer to Distributing the sealan t. Then repeat steps 1to4.If an inflation pressure of 1.8 bar/26 psi still can-not be reached, then the tire is too heavily dam-aged. Contact your ne arest MINI dealer.<Driving onDo not exceed the permitted maximum speed of 50 mph/80 km/h; doing so may result in an accident. <Replace the defective tire as soon as possible and have the new wheel/tire assembly bal-anced.Have the Mobility Kit refilled.
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
33004 view
11935 view
42913 view
3538 view
28679 view
もっと見る