1. 取扱説明書・マニュアル >
2. MINI >
3. 自動車 >
4. MINI の使い方、故障・トラブル対処法 >
5. MINI の取扱説明書・マニュアル

MINIの取扱説明書・マニュアル [全267ページ 2.77MB]

Replacing components MOBILITY 219MINI Clubman: changing the rear wiper blade1.Fold out the wiper arm and hold it.2.Compress the locking spring, arrow 1, and fold out the wiper blade.3.Pull the wiper blade away from and out of the catch mechanism, arrow 2.4.Press the new wiper blade into the fixture until it engages audibly.Lamps and bulbsLamps and bulbs make an essential contribution to vehicle safety. They should, therefore, be handled carefully. The manufacturer of your MINI recommends having your MINI dealer per-form any work that you do not feel competent to perform yourself or that is not described here.Never touch the glass of new bulbs with your bare fingers, as even minute amounts of contaminatio n will burn into the bulb's surface and reduce its service life. Use a clean tissue, cloth or some thing similar, or hold the bulb by its base. <You can obtain a selection of replacement bulbs at your MINI dealer.Only replace bulbs after they have cooled down; otherwise, you may burn your fin-gers.<When working on electrical systems, always begin by switching off the con-sumer in question; otherwise, short circuits could result. To avoid possible injury or equip-ment damage when replacing bulbs, observe any instructions provided by the bulb manufac-turer.<Caring for headlamps, refer to page 214.For any bulb replacement not described below, contact a MINI dealer or a work-shop that has specially trained personnel work-ing in accordance with th e specifications of the MINI manufacturer. <For checking and adjusting headlamp aim, please contact your MINI dealer. <Light-emitting diodes LEDsLight-emitting diodes installed behind translu-cent lenses serve as the light sources for many of the controls and displays in your vehicle. These light-emitting diodes are related to conven-tional laser diodes, and legislation defines them as Class 1 light-emitting diodes.Do not remove the covers or expose the eyes directly to the unfiltered light source for several hours; otherwise, this could cause irritation of the retina. <Headlamp glass lensIn cool or humid weather, condensation may occur on the interiors of the headlamps. The condensation disappears a short time after the light is switched on. The headlamps do not need to be changed.Do not remove the condensation from head-lamps, despite driving with lights on, and if con-densation increases, e.g., because of water droplets, have this checked by your MINI dealer.Xenon lampsThe service life of these bulbs is very long and the probability of failure very low, provided that they are not switched on and off an excessive number of times. If a xenon lamp fails neverthe-less, switch on the fog lamps and continue the journey with great care, provided that local leg-islation does not prohibit this.Work on the xenon lighting system, including lamp replacement, is only to be

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.