1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. X3 の使い方、故障・トラブル対処法 >
5. X3 の取扱説明書・マニュアル

X3の取扱説明書・マニュアル [全132ページ 3.62MB]

ReferenceAt a glanceControlsDriving tipsMobility 103Tailgate lamp5 Watt bulb 1.Pull off the bulb holder2.Replace the bulb.Light-emitting diodes LEDsLight-emitting diodes installed behind translucent lenses serve as the light source for many of the controls and displays in your vehicle. These light-emitting diodes, which operate using a concept similar to that applied in conventional lasers, are offi-cially designated as Class 1 light-emitting diodes.Do not remove the covers, and never stare into the unfiltered light for sev-eral hours, as irritation of the retina could result.<Changing a wheel Safety precautions to observe in the event of a flat tire and during all tire changes:Park the vehicle as far as possible from passing traffic. Park on a firm, flat, surface. Switch on the hazard warning flashers.Lock the steering wheel in straight-ahead setting of the wheels. Set the handbrake and engage first gear, reverse gear or selector-lever position P.All passengers should be outside the vehi-cle and well away from your immediate working area, behind a guardrail, for instance.If a warning triangle or portable hazard warning lamp is required, set it up on the roadside at an appropriate distance from the rear of the vehicle. Comply with all safety guidelines and regulations.Change the wheel only on a level, firm sur-face which is not slippery. The vehicle or the jack could slip to the side if you attempt to raise the vehicle on a soft or slippery sur-face such as snow, ice, tiles, etc. Position the jack on a firm support surface.Do not use a wooden block or similar object as a support base for the jack, as this would prevent it from extending to its full support height and reduce its load-car-rying capacity.To avoid serious or fatal injury: never lie under the vehicle, and never start the engine while it is supported by the jack. < What you will need Open tailgate and raise or remove floor cover, refer to page 72. 1Vehicle jack 2Chock 3Lug wrench In order to avoid rattling noises later, note the position of the tools when you remove them and return them to their original posi-tion when you are through using them.Compact wheelThe compact wheel is located under the cargo area on the floor of the vehicle.

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.