X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123804.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123804.pdf - 3.62MB
- キャッシュ
25908view
132page / 3.62MB
Driving38sion control system components, espe-cially the catalytic converter.Service Engine Soon indicator lamp for Canadian models.Malfunction in the engine electron-ics. You can continue to drive with reduced engine output or engine speed. Please have it checked by your BMW Sports Activity Vehicle Center.Starting the engineWhen starting the engine, do not press the accelerator pedal. Vehicles with manual transmission:Step on the clutch when starting the vehicle. A lockout prevents the engine from starting if the clutch is not depressed. <Do not actuate the starter for too short a time. Do not turn it for more than approx. 20 seconds. Release the igni-tion key immediately as soon as the engine starts.<If the engine fails to start on the first attempt, for instance, if it is very hot or cold:>Press the accelerator pedal halfway down while engaging the starter. During a cold start at very low tempera-tures, as of approx. +5 7/-156, at high altitudes over 3,300 ft/1,000 m:>For the first attempt, run the start for longer, approx. 10 seconds >Press the accelerator pedal halfway down while engaging the starter.Avoid frequent starting is quick suc-cession or repeated start attempts in which the engine does not start. Otherwise, the fuel is not burned or inadequately burned and there is a danger of overheat-ing and damaging the catalytic converter. <Manual transmission1.Engage the handbrake2.Gearshift lever in idle position3.Press the clutch pedal4.Start the engine.Before leaving the vehicle with the engine running, place the gearshift lever in idle position and apply the hand-brake.Never leave an unattended vehicle with the engine running, as such a vehicle repre-sents a potential safety hazard. <Automatic transmission1.Press the brake pedal2.Place the selector lever in position P or N3.Start the engine.To prevent the vehicle from rolling, always select position P and engage the handbrake before leaving the vehicle with the engine running. Never leave an unattended vehicle with the engine running, as such a vehicle repre-sents a potential safety hazard. <Switching off the engineDo not remove the ignition key when the vehicle is moving, as otherwise the steering could lock.When leaving the vehicle, always remove the ignition key and lock the steering.When parking on downward inclines, apply the handbrake.<Manual transmissionTurn the ignition key to position 1 or 0.Automatic transmissionEngage selector-lever position P, turn igni-tion key to position 1 or 0.HandbrakeThe handbrake is primarily intended to pre-vent the vehicle from rolling while parked; it brakes the rear wheels. Indicator lampThe indicator lamp lights up from ignition switch position 2 with the handbrake set - an acoustic signal also sounds when starting off.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
21244 view
23290 view
もっと見る