X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123805.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123805.pdf - 3.62MB
- キャッシュ
26085view
132page / 3.62MB
ReferenceAt a glanceControlsDriving tipsMobility 67The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.The equipment can be used as of ignition key position 2.If the device cannot be operated after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions of the original hand-held transmitter or press and hold down the programmed memory button 1 of the integrated universal remote control. If the indicator lamp 2 on the integrated uni-versal remote control flashes rapidly for a short time then lights up for approx. 2 sec-onds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at the section on alternating-code transmitters. <Alternating-code transmitters Consult the operating instructions of the unit you wish to set when programming the universal remote control. You will find infor-mation there on the possibilities for syn-chronization.When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person. <1.Park your vehicle within the range of the remote-controlled device 2.Program the integrated universal remote control as described above at Fixed-code hand-held transmitters 3.Locate the button at the receiver of the equipment to be set, e.g. on the drive 4.Press the button on the receiver of the device you want to set up. After step 4, you have approx. 30 seconds for step 55.Press the programmed memory button 1 of the integrated universal remote control three times. The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. If you have questions, please contact your BMW Sports Activity Vehicle Center.<Clearing the memory buttons Press both outer buttons 1 of the inte-grated universal remote control for approx. 20 seconds, maintaining pressure until the indicator lamp 2 starts to flash. All three memory buttons are cleared. The memory of individual memory buttons 1 cannot be cleared. Beverage holdersFrontDepending on your optional equipment, the center console contains either one or two beverage holders.Passenger's side*The beverage holder for the front passen-ger is located beneath the air/heating vent.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53119 view
20837 view
20989 view
23008 view
22105 view
もっと見る