X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
21243view
126page / 4.65MB
Driving38To use the automatic function again, move the selector lever to the right into position D.Malfunction The warning lamp lights up. A malfunc-tion has occurred in the transmission system. Avoid heavy loads.While it will still remain possible to move the selector lever to any desired position, the trans-mission will revert to its default mode with only a limited number of forward gears. Have the system checked as soon as possible.Information on towing and jump starting, refer to page105. Turn signals/headlamp flasher 1High beams2Headlamp flasher3Turn signalsAtypically rapid flashing of the indicator lamp indicates that a turn signal bulb has gone out. After the ignition is switched off, make sure that the roadside parking lamps have not been left on.< Signaling brieflyPress lever to resistance point and hold for as long as you wish to signal.Washer/wiper system/rainsensor* 0Wipers retracted 1Intermittent or rain sensor operation2Normal wiper speed3Fast wipe4Brief wipe5Select interval time or set sensitivity of rain sensorFold-out positionThe right wiper is partially concealed by the hood. To move the wipers into a vertical position:1.Switch on wipers in lever position 1.2.When the wipers are approximately vertical, move the ignition key to position 0.For changing the wiper blades, refer to page 95.Fold the wipers back down onto the wind-shield before you turn the ignition key to position 1 or 2 again. If you do not, they could be damaged.<Intermittent modeNot on vehicles with rain sensor.You can set the wipe interval to four stages with the serrated dial 5. In addition, the wipe interval is varied automati-cally depending on road speed.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21397 view
23409 view
22606 view
もっと見る