X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
21243view
126page / 4.65MB
ReferenceAt a glanceControlsDriving tipsMobility 63The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can use the system when the engine is run-ning or when the ignition is switched on.If the system cannot be operated after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions of the original hand-held transmit-ter or press and hold down the programmed memory button 1 of the integrated universal remote control. If the indicator lamp 2 on the integrated universal remote control flashes rap-idly for a short time then lights up for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code sys-tem. In the case of an alternating-code system, program the memory buttons 1 as described at the section on alternating-code transmitters. <Alternating-code transmitters Consult the operating instructions of the unit you wish to set when programming the univer-sal remote control. You will find information there on the possibilities for synchronization.When programming hand-held transmitters that employ an alternating code, please follow these additional instructions: Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled equipment. 2.Program the integrated universal remote control as described above at Fixed-code hand-held transmitters. 3.Locate the button at the receiver of the equipment to be set, e.g. on the drive. 4.Press the button on the receiver of the device you want to set up. After step 4, you have approx. 30 seconds for step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times. The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. If you have questions, please contact your BMW Sports Activity Vehicle Center. <Clearing memory buttons Press both outer buttons 1 for approx. 20 sec-onds until the indicator lamp 2 starts to flash: all of the memory buttons are cleared. The memory of individual memory buttons 1 cannot be cleared. Cup holders FrontDepending on your optional equipment, the center console contains either one or two cup holders.Passenger side*The cup holder for the front passenger is located beneath the air/heating vent.1.Press the trim piece below the air/heating vent, arrow.2.Insert cup.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21397 view
23409 view
22606 view
もっと見る