X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123807.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123807.pdf - 4.65MB
- キャッシュ
21244view
126page / 4.65MB
ReferenceAt a glanceControlsDriving tipsMobility 35Display of the previously described malfunction on Canadian models.The warning lamp lights up. Malfunc-tion in the engine electronics. You can continue to drive with reduced engine output or speed. Have the system checked immediately.Starting engine When starting the engine, do not press the accelerator pedal. Vehicles with manual transmission:Step on the clutch when starting the vehicle. A locking mechanism prevents the engine from starting if the clutch is not depressed.Do not end the starting procedure too early, but do not prolong it for more than 20 seconds. Release the ignition key immediately as soon as the engine starts.If the engine fails to start on the first attempt, for instance, if it is very hot or cold:Press the accelerator pedal halfway down while engaging the starter. During a cold start at very low temperatures, below approx. +57/-156, at high altitudes over 3,300 ft/1,000 m:>Engage the starter for approx. 10 seconds the first time.>Press the accelerator pedal halfway down while engaging the starter.Avoid frequent starting in quick succes-sion or repeated start attempts in which the engine does not start. Otherwise, the fuel is not burned or inadequately burned and there is a danger of overheating and damaging the cat-alytic converter.<Manual transmission1.Apply the handbrake.2.Shift into neutral.3.Press the clutch pedal.If the clutch pedal is not pressed, the engine cannot be started.4.Start the engine.Before leaving the vehicle with the engine running, place the gearshift lever in neu-tral position and engage the handbrake.Never leave an unattended vehicle with the engine running, as such a vehicle represents a potential safety hazard. <Automatic transmission1.Press the brake pedal.2.Engage selector-lever position P or N.3.Start the engine.To prevent the vehicle from rolling, always select position P and engage the handbrake before leaving the vehicle with the engine running. Never leave an unattended vehicle with the engine running, as such a vehi-cle represents a potential safety hazard. <Switching off engine Do not remove the ignition key when the vehicle is moving, as otherwise the steer-ing could lock.When leaving the vehicle, always remove the ignition key and lock the steering.When parking on downward inclines, engage the handbrake.<Manual transmissionTurn the ignition key to position 1 or 0.Automatic transmissionEngage selector-lever position P, turn ignition key to position 1 or 0.Handbrake The handbrake is primarily intended to prevent the vehicle from rolling while parked; it brakes the rear wheels. Indicator lamp The indicator lamp lights up red. An acoustic signal also sounds when you begin to drive. The handbrake is engaged.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
23290 view
22420 view
もっと見る