X3の取扱説明書・マニュアル [全140ページ 3.36MB]
123810.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123810.pdf - 3.36MB
- キャッシュ
21909view
140page / 3.36MB
ReferenceAt a glanceControlsDriving tipsMobility 113Inserting compact wheelThe compact wheel is reinserted in the reverse sequence of its removal.When attaching the retaining strap to the compact wheel, make sure the belt is threaded through 2 rim openings, with one unoccupied hole between them; otherwise, the compact wheel could come loose in an acci-dent.<Preparing wheel change1.Observe the safety precautions on page112.2.Secure the vehicle to prevent it from rolling: Place the wheel chock behind the front wheel on the side of the vehicle opposite the side being raised. If the vehicle is parked on a downward slope, place the wheel chock securely in front of this wheel. If the road surface is steeply inclined, take addi-tional preventive steps to stop the vehicle from rolling.3.Loosen the wheel lugs by a half turn.Jacking up vehicle1.Position the vehicle jack at the jacking point closest to the wheel so that the entire sur-face of the jack base perpendicularly con-tacts the ground under the jacking point.The vehicle jack is designed for changing wheels only. Do not attempt to raise another vehicle model with it or to raise any load of any kind. To do so could cause accidents and personal injury. <2.Guide the jack head into the rectangular recess of the jacking point when cranking up, refer to drawing inset.3.Jack the vehicle up until the wheel you are changing is raised from the ground.Mounting a wheel1.Unscrew the lug bolts and remove the wheel.2.Remove accumulations of mud or dirt from the mounting surfaces of the wheel and hub. Clean the lug bolts.3.Position the new wheel or compact wheel. Secure the wheel by screwing at least two lug bolts into opposite bolt holes. When you mount wheels other than Genuine BMW light-alloy wheels, different lug bolts may also be required.4.Screw in the remaining lug bolts. Tighten all the bolts securely in a diagonal pattern.5.Lower the jack and remove it from beneath the vehicle.After mounting1.Tighten the lug bolts in a diagonal pattern.To ensure safety, always have the lug bolts checked with a calibrated torque wrench as soon as possible to ensure that they are tightened to the speci-fied torque. The tightening torque is 101lbft/140Nm. <2.Stow the defective wheel in the cargo area.3.Check and correct the tire inflation pressure at the earliest opportunity.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
21244 view
23290 view
もっと見る