X3の取扱説明書・マニュアル [全146ページ 4.87MB]
123811.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123811.pdf - 4.87MB
- キャッシュ
22324view
146page / 4.87MB
Replacing components114For bulb replacement procedure, refer to Driver's side.Halogen high beamsH7 bulb, 55 wattsAlways wear gloves and eye protection - the atmosphere inside the H7 bulb is pressurized. Failure to observe this precaution can lead to injuries sh ould the bulb be dam-aged.<For checking and adjusting headlamp aim, please contact your BMW Sports Activity Vehicle Center. <Driver's side1.Open the clip and re move the lamp cover.2.Press the bulb holder downward and remove, refer to Low beams.3.Pull off the lamp base; plug in a new lamp base.4.Place the lamp base with the lower edge against the bracket and press it in until the lamp base locks into place.Make sure that the cover does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered.<Front passenger sideBefore replacing the bulb , remove the reservoir of the windshield washer system from the bracket, refer to Ha logen low beams on page113.For bulb replacement procedure, refer to Driver's side.Parking and roadside parking lampsW5W bulb, 5 wattsA bulb is located ov er each high beam.1.Remove bulb cover for high beams, refer to Halogen high beams.2.Remove bulb holder.3.Remove and replace the bulb.Turn signal, frontLamp PSY24W, 24 Watt or PSY24W Silver Vision*Access to the turn signal is at the edge of the lamp unit, refer to arrow.Make sure that the la mp base does not fall into the engine compartment; otherwise, the vehicle can be damage d or other road users can be endangered. <1.Turn the lamp base and remove it.2.Replace the bulb.3.Insert the lamp base. If it does not snap into place immediately, turn the lamp base until it does.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
55002 view
26736 view
21292 view
21436 view
23456 view
もっと見る