Z4の取扱説明書・マニュアル [全120ページ 3.44MB]
123816.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123816.pdf - 3.44MB
- キャッシュ
28338view
120page / 3.44MB
Replacement procedures88Replacement proceduresOnboard tool kitThe onboard tool kit is stored in a tool pouch. It is located in the luggage compart-ment beneath the floor panel.Windshield wiper blades 1.Fold the wiper arm completely out from the windshield 2.Position the wiper blade at an angle and pull the release spring, see arrow 3.Fold the wiper blade down and unhook it toward the windshield4.Pull the wiper blade past the wiper arm toward the top 5.Insert a new wiper blade and apply pressure until you hear it engage.Lamps and bulbs The lamps and bulbs make essential contri-butions to the safety of your vehicle. There-fore, comply fully with the following instruc-tions during bulb replacement. If you are not familiar with the procedures, BMW rec-ommends that you have your BMW center carry out the work.Do not touch the glass portion of a new bulb with your bare hands since even small amounts of impurities burn in to the surface and reduce the ser-vice life of the bulb. Use a clean cloth, paper napkin or a similar material, or hold the bulb by its metallic base. <A replacement bulb set is available from your BMW center.Before working on the electrical sys-tem, switch off the electrical acces-sory you are working on or disconnect the cable from the negative terminal of the bat-tery. Failure to observe this precaution could result in short circuits.To prevent injuries and damage, always comply with any instructions provided by the bulb manufacturer. <Accessing the headlampsProtective cover in the wheel wellTo gain access to the headlamp covers, turn the front wheels in the required direc-tion.
参考になったと評価
18人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る