1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. Z4 の使い方、故障・トラブル対処法 >
5. Z4 の取扱説明書・マニュアル

Z4の取扱説明書・マニュアル [全120ページ 3.82MB]

Driving36DrivingIgnition lock 0 Steering locked This is the only position in which the ignition key can be inserted or removed.After removing the key, turn the steering wheel slightly to the left or ri ght until the lock engages.If the key is not removed, an acoustic signal sounds when the driver's door is opened.Interlock Vehicles with automatic transmission:In order to turn the key back to position 0 or to remove it, move the select or level into position P first.1 Steering unlockedYou will find that it is often easier to turn the ignition key from position 0 to 1 if you move the steering wheel slightly to help disengage the detent.Individual electrical equipment and accessories are available for use.2 Ignition switched on All systems are operational.3 Starting engineEngine Engine idle speed is co ntrolled by the engine computer system. Increased speeds at start-up are normal and should decrease as the engine warms up. If engine speed does not decrease, service is required.To prevent the battery fr om discharging, always deactivate electrical devi ces that are not in use. Switch the ignition off when the vehicle is not being driven.Do not leave the engine running in enclosed spaces. Otherwise, inhaling the hazardous exhaust gases could lead to uncon-sciousness and death. The exhaust gases con-tain carbon monoxide, an odorless and color-less, but highly toxic gas. Do not leave the vehicle unattended with the engine running. An unattended vehicle with a running engine poses a safety hazard. Before you leave the vehicle with the engine running, place the engine in idle first or engage the P position and apply the parking brake. If you fail to do this, th e vehicle could move. <Starting the engine Do not press the accele rator pedal while start-ing the engine.Do not let the engine warm up in idling position. Instead, begin to drive at moderate engine speeds.Vehicles with manual transmission:Step on the clutch when starting the vehi-cle. A lockout prevents the engine from starting if the clutch is not depressed. <Do not end the starting procedure too early, but do not continue it for more than 20 seconds. Release the ignition key immediately when the engine starts.If the engine fails to st art on the first attempt, e.g. if it is very hot or cold:Press the accelerator pedal halfway down.Cold starts at very low temperatures, below approx. +57/-156, and at high altitudes, above 3,300 ft/1,000 m:

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.