Z4の取扱説明書・マニュアル [全132ページ 3.23MB]
123844.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123844.pdf - 3.23MB
- キャッシュ
21004view
132page / 3.23MB
ReferenceAt a glanceControlsDriving tipsMobility 41Automatic transmission1.Depress the brake.2.Start the engine.Special starting conditionsIn the following situations, press the accelerator pedal halfway down when starting the engine:>If the engine does not start on the first attempt, for instance when it is extremely hot or cold.>If the engine is started at very low tempera-tures, below approx. +5 7/-156, at high altitudes above approx. 3,300 ft/1,000 m.Avoid frequent starting attempts in quick succession or repeated starting attempts during which the engine does not start. Other-wise, the fuel is not burned or inadequately burned; there is a danger of overheating and damaging the catalytic converter. <Switching off the engineDo not remove the key while the vehicle is still moving. Otherwise, the steering lock would engage when the steering wheel is turned. When you leave the vehicle, always remove the key and engage the steering lock.Apply the parking brake when parking on steep gradients, otherwise the vehicle could start to roll.<You can have an acoustic signal set as a reminder that the key is still in the ignition switch after the driver's door has been opened.<Manual transmission1.Turn the key to position 1 or 0.2.Engage first gear or reverse gear.3.Apply the parking brake.Automatic transmission1.With the car at a standstill, move the selec-tor lever to position P.2.Turn the key to position 1 or 0.Parking brakeThe parking brake is designed primarily to pre-vent the vehicle from rolling when parked. It operates against the rear wheels.Indicator lampThe indicator lamp is lit, and when you drive off a signal sounds in addition. The parking brake is still applied.Indicator lamp for Canadian models.ApplyingThe lever locks in position automatically.ReleasingPull slightly upwards, press the button and lower the lever.If, in exceptional circumstances, it should be necessary to engage the parking brake while the vehicle is in motion, do not pull it with excessive pressure. In doing so, continuously press the button of the parking brake lever. Oth-erwise, too violent an application of the parking brake can overbrake the rear axle and cause the rear of the car to swerve. <To prevent corrosion and one-sided brak-ing action, occasionally apply the parking brake lightly when the vehicle is slowly coming to a stop if the traffic conditions are suitable.The brake lamps do not light up when the park-ing brake is applied. <
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る