Z4の取扱説明書・マニュアル [全132ページ 3.23MB]
123844.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123844.pdf - 3.23MB
- キャッシュ
20990view
132page / 3.23MB
Everything under control50Setting the clock1.Press button 2 for several seconds until the hours are displayed and the colon flashes.2.Press button1 repeatedly until the required hour is set.3.Press button2 to switch to the minutes dis-play.4.Press button1 repeatedly until the required minutes are set.5.Press button2 to confirm the time.The set time of day is transferred to the car radio display or appears in the instrument clus-ter display.Computer*To view the information on the instrument clus-ter display, press the onboard computer button BC in the turn signal lever.Each time you tap the onboard computer but-ton, the following information is shown in the specified order:>Time>Outside temperature>Average fuel consumption>Cruising range>Average speedWith the ignition key in position 1 or higher, the respective last active setting is displayed.If you wish, you can have all the following information displayed in another unit of measure.<Setting the time formatYou can have the clock displayed in 12h or 24h mode:While the time display is active, press the onboard computer button BC in the turn signal lever until the display changes.Changing unit of measure: F/CWhile the outside temperature display is active, press the onboard computer button BC in the turn signal lever until the display changes.Average fuel consumptionThe average fuel consumption is calculated for the time for which the engine has been running.To reset the average fuel consumption display:Press the onboard computer button BC in the turn signal lever for approx. 2 seconds.Cruising rangeThe computer bases its calculations of the cruising range on the preceding driving style and on the amount of fuel remaining in the tank.Be sure to refuel as soon as possible once your cruising range falls below 30 miles/50 km, otherwise engine functions are not ensured and damage can occur. <Average speedThe average speed is calculated for the time for which the engine has been running.To reset the average speed display:Press the onboard computer button BC in the turn signal lever for approx. 2 seconds.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
38310 view
31118 view
13898 view
21354 view
21050 view
もっと見る