Z4の取扱説明書・マニュアル [全132ページ 3.23MB]
123844.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123844.pdf - 3.23MB
- キャッシュ
20792view
132page / 3.23MB
ReferenceAt a glanceControlsDriving tipsMobility 87All passenger car tires must conform to Federal Safety Requirements in addition to these grades.<Tread wearThe tread wear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified gov-ernment test course. For example, a tire graded 150 would wear one and one-half, 1 γ, times as well on the govern-ment course as a tire gr aded 100. The relative performance of tires depends upon the actual conditions of their us e, however, and may depart significantly from the norm due to varia-tions in driving habits, service practices and dif-ferences in road characteristics and climate.TractionThe traction grades, from highest to lowest, are AA, A, B and C. Those grades represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified government test sur-faces of asphalt and concrete. A tire marked C may have poor traction performance.The traction grade assigned to this tire is based on straight-ahead braking traction tests, and does not include acceleration, cor-nering, hydroplaning, or peak traction charac-teristics.<TemperatureThe temperature grades are A, the highest, B and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel. Sustained high temperature can cause the material of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure. The grade C corresponds to a level of performance which all passenger car tires must meet under the Federal Motor Vehi-cle Safety Standard No. 109. Grades B and A represent higher levels of performance on the laboratory test wheel than the minimum required by law.The temperature grade for this tire is established for a tire that is properly inflated and not overloaded. Excessive speed, underinflation, or excessive loading, either sep-arately or in combination, can cause heat buildup and possible tire failure. <RSC: Run-Flat Tires Run-Flat tires are labeled on the sidewall with a circular symbol containing the letters RSC. Refer to page88.M+SWinter and all-season tires.These have better winter performance proper-ties than summer tires.Tire conditionInspect your tires frequently for tread wear, signs of damage and for foreign objects lodged in the tread. Check the tread depth.Minimum tread depthThe tread depth should not drop below 1/8 in/3 mm, although, for example, European legisla-tion only specifies a minimum tread depth of 1/16 in/1.6 mm. At tread depths below 1/8 in/3 mm there is an increased risk of high-speed hydroplaning, even when only small amounts of water are present on the road surface.When winter tires wear down past a tread depth of 1/6 in/4 mm, they become perceptibly less suitable for winter conditions. In the interest of safety, new tires should be installed.Wear indicators in the base of the tread groove are distributed around the tire's circumference;
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
37917 view
30843 view
13798 view
21136 view
20883 view
もっと見る