1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. Z4 の使い方、故障・トラブル対処法 >
5. Z4 の取扱説明書・マニュアル

Z4の取扱説明書・マニュアル [全248ページ 7.63MB]

Practical interior accessories98Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universal remote control can replace as many as three hand-held transmit-ters for various remote-controlled devices, such as garage doors and gates or lighting sys-tems. The integrated un iversal remote control registers and stores signals from the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. After this, the programmed memory button1 will operate the system in question. The LED 2 flashes to confirm trans-mission of the signal.Should you sell your vehicle one day, be sure to delete the stored progra ms beforehand for your safety, refer to page 99.To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to ma ke certain that no peo-ple, animals or objects are within the pivoting or travel range of the device being operated. Com-ply also with the safety instructions supplied with the original hand-held transmitter. <Checking compatibilityIf this symbol appears on the package or in the instructions supplied with the original hand-held transmitter, you can assume that the radio re mote control device will be compatible with the integrated universal remote control.For additional information, please contact your BMW center or call: 1-800-355-3515.You can also obtain information on the Internet at: www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark of Johnson Controls, Inc.<Programming1Memory buttons2LEDFixed-code hand-held transmitters1.Switch on the ignition, refer to page 50.2.When starting operation for the first time: press the left and right memory buttons 1 for approx. 20 seconds until the LED 2 flashes rapidly. The three memory buttons are cleared.3.Hold the original hand-held transmitter at a distance of approx. 4 to 12 in/10 to 30 cm from the memory buttons 1.The required distance between the hand-held transmitter and the mem-ory buttons1 depends on the system of the respective original hand-held transmit-ter used.<4.Simultaneously press the transmit key on the original hand-hel d transmitter and the desired memory button 1 on the integrated universal remote control. The LED 2 flashes slowly at first. As soon as the LED 2 flashes rapidly, release both buttons. If the LED 2 does not flash rapidly after approx. 15 sec-onds, alter the distance and repeat this step.5.To program other original hand-held trans-mitters, repeat steps 3 and 4.

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.