Z4の取扱説明書・マニュアル [全254ページ 8.04MB]
123875.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123875.pdf - 8.04MB
- キャッシュ
39107view
254page / 8.04MB
Practical interior accessories100Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universal remote control can replace as many as three hand-held transmit-ters for various remote-controlled devices, such as garage doors and gates or lighting sys-tems. The integrated un iversal remote control registers and stores signals from the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. After this, the programmed memory button1 will operate the system in question. The LED 2 flashes to confirm trans-mission of the signal.Should you sell your vehicl e one day, be sure to delete the stored progra ms beforehand for your safety, refer to page 101.To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to ma ke certain that no peo-ple, animals or objects are within the pivoting or travel range of the device being operated. Com-ply also with the safety instructions supplied with the original hand-held transmitter. <Checking compatibilityIf this symbol appears on the package or in the instructions supplied with the original hand-held transmitter, you can assume that the radio re mote control device will be compatible with the integrated universal remote control.For additional information, please contact your BMW center or call: 1-800-355-3515.You can also obtain information on the Internet at: www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark of Johnson Controls, Inc.<Programming1Memory buttons2LEDFixed-code hand-held transmitters1.Switch on the ignition, refer to page 50.2.When starting operation for the first time: press the left and right memory buttons 1 for approx. 20 seconds until the LED 2 flashes rapidly. The three memory buttons are cleared.3.Hold the original hand-held transmitter at a distance of approx. 4 to 12 in/10 to 30 cm from the memory buttons 1.The required distance between the hand-held transmitter and the mem-ory buttons1 depends on the system of the respective original hand-held transmit-ter used.<
参考になったと評価
21人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る