Z4の取扱説明書・マニュアル [全254ページ 8.04MB]
123875.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123875.pdf - 8.04MB
- キャッシュ
39107view
254page / 8.04MB
Giving and receiving assistance2202.Attach one terminal clamp of the plus/+ jumper cable to the positive terminal of the battery or a starting-aid terminal of the vehi-cle providing assistance.3.Attach the second te rminal clamp of the plus/+ jumper cable to the positive terminal of the battery or a star ting-aid terminal of the vehicle to be started.4.Attach one terminal clamp of the minus/- jumper cable to the nega tive terminal of the battery or to an engine or body ground of the assisting vehicle. Your BMW has a special nut as body ground or negative pole.5.Attach the second te rminal clamp of the minus/- jumper cable to the negative termi-nal of the battery or to the engine or body ground of the vehicle to be started.Starting the engine1.Start the engine of the donor vehicle and allow it to run for a few minutes at slightly increased idle speed.2.Start the engine on the other vehicle in the usual way. If the first start attempt is not successful, wait a few minutes be fore another attempt in order to allow the discharged battery to recharge.3.Let the engines run for a few minutes.4.Disconnect the jumper cables by reversing the above connecting sequence.If necessary, have th e battery checked and recharged.Never use spray fluids to start the engine.<Tow-starting, towing awayObserve the applicable laws and regula-tions for tow-starting and towing vehicles.<Do not transport an y passengers other than the driver in a vehicle that is being towed.<Using a tow fittingThe screw-in tow fitting must always be carried in the car. It can be sc rewed in at the front or rear of the BMW.It is stored in the onboard vehicle tool kit under-neath the floor panel in the cargo area, refer to page212.Use only the towing eyelet supplied with the vehicle and screw it in firmly until it stops. Use the tow fitting for towing on paved roads only. Avoid lateral loading of the tow fit-ting, e.g., do not lift the vehicle by the tow fitting. Otherwise, the tow fitting and the vehicle could be damaged.<Access to screw threadFrontRelease the cover pa nel in the bumper:Press on the recess at the bottom left in the cover panel.
参考になったと評価
21人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る