1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. Z4 の使い方、故障・トラブル対処法 >
5. Z4 の取扱説明書・マニュアル

Z4の取扱説明書・マニュアル [全254ページ 8.04MB]

Driving58>To shift down: press one of the shift pad-dles forward, arrow 2.Gears can be shifted usin g the shift paddles in drive mode or in manual mode.Gear change in manual mode:When manual mode is active, refer to page 57, gears can be changed using the shift paddles or the selector lever.Gear change in drive modeThe shift paddles can be used to change gears in drive mode as well.Afterwards, if the shift paddles are not used for some time and vehicle ac celeration is insuffi-cient, the forward gears are changed again automatically.Launch ControlLaunch Control enables you to drive off with an optimal vehicle acceleration on a high grip road surface.Do not use Launch Control too often, as the higher loads on the vehicle lead to premature component wear. <Launch Control is availa ble when the engine is at operating temperature, i.e., after driving con-tinuously for at least 6 miles/10 km.1.With the engine running, depress the brake pedal with your left foot.2.Activate the SPORT+ program of the Dynamic Driving Control, refer to page 79.3.With the vehicle stationary, activate manual mode and select first gear.4.Press the accelerator all the way down. The engine speed when driving off is controlled. A flag symbol appears in the instrument cluster.5.The vehicle accelerates when you release the brake pedal. Keep the accelerator pressed all the way down.6.The transmission shifts up automatically as long as the accelerator is pressed all the way down.Launch Control only becomes available again after a certain distance has been driven.Launch Control can only be used after the break-in phase, refer to page 112.To maintain driving stability, activate DSC whenever possible. <Manually releasing and engaging the transmission lockIf a power failure occurs, e.g., if the battery is discharged or disconnected or if there is an electrical malfun ction, the transmission lock must be released manually; otherwise, the rear wheels are blocked and the vehicle cannot be towed.<Release the transmission lock manually for tow-ing only and set the parking brake beforehand to prevent the vehicle from rolling. After parking the vehicle, lock the transmission lock again manually, refer to page 59.Manual release1.Unclip the sleeve of the selector lever.2.Pull the sleeve up over the selector lever until the sleeve is inside out.3.Insert the Allen wrench from the onboard vehicle tool kit, refer to page 212, into the cap.

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.