Z4の取扱説明書・マニュアル [全254ページ 8.04MB]
123875.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123875.pdf - 8.04MB
- キャッシュ
39107view
254page / 8.04MB
Lamps90High beams/roadside parking lamps1High beams2Headlamp flasher3Roadside parking lamps*Roadside parking lamps, left or right*There is an additional option of switching on the lamps on the side of the car facing the road when parked.Switching onAfter parking the vehicle, press the lever up or down beyond the pressu re point for a longer period, arrow 3.The roadside parking lamps drain the bat-tery. Therefore, do not leave them on for unduly long periods of time; otherwise, the bat-tery might not have enou gh power to start the engine.<Switching offPress the lever in the o pposite direction to the pressure point, arrow 3.High-Beam Assistant*The conceptThis system automatica lly switches the high beams on and off. The procedure is controlled by a sensor on the front of the interior rearview mirror. The assistant en sures that the high beams are switched on whenever the traffic sit-uation allows. It handle s this task for you and gives you the benefit of the best possible view. You can intervene at any time and switch the high beams on and off as usual.Activating the system1.Turn the light switch to position 3, refer to page88.2.With the low beams switched on, briefly push the turn indicator lever in the direction of the high beam.The indicator lamp in the instrument cluster lights up when the high beams are activated. The system automati-cally switches from high beams to low beams and vice versa in response to oncoming traffic, traffic ahead of you, and adequate ambient lighting, e.g., on city streets.Switching the high beams on and off manuallyWhenever you wish, or when the situation requires, you can intervene:>If the high-beam assistant switches on the high beams, but you wo uld like to drive with the low beams, simply switch off the high beams using the turn indicator lever. This deactivates the high-beam assistant. To reactivate the system, briefly push the turn indicator lever to ward the high beams again.>If the high-beam assistant switches on the low beams, but you would like to drive with the high beams, switch on the high beams as usual. This deactivates the system and the high beams need to be switched off manually, if necessary.To reactivate the system, briefly push the turn indicator lever to ward the high beams again.>Use the headlamp flasher as usual with the low beams switched on.
参考になったと評価
21人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る