シボレートレイルブレイザーの取扱説明書・マニュアル [全432ページ 2.90MB]
103530.pdf
http://153.127.246.254/.../103530.pdf - 2.90MB
- キャッシュ
54935view
432page / 2.90MB
2-82. Turn the key to RUN and LOCK twice. Then, with the key in LOCK, release the turnsignal/multifunction lever. Once you do this, youwill hear the lock switch lock and unlock, the hornwill chirp twice, and a 30 second program timer will begin.3. You are now ready to program the automatic doorlocks. Select one of the three programming optionslisted above, and press the lock side of the powerdoor lock switch to cycle through the lock options.You will have 30 seconds to begin programming. If you exceed the 30 second limit, the locks willautomatically lock and unlock and the horn willchirp twice to indicate that you have left the programmode. If this occurs, repeat the procedure beginningwith Step 1 to re-enter the programming mode.You can exit the program mode any time by turning theignition to RUN (the locks will automatically lock andunlock and the horn will chirp twice to indicate that you are leaving the program mode). If the lock/unlockswitches are not pressed while in the programmingmode, the current auto lock/unlock setting will not be modified.See your dealer for more information.Programmable Unlocking FeatureThe following is the list of available programming options:Mode 1: Driver's door unlocks when thetransmission is shifted into PARK (P).Mode 2: All doors unlock when the transmission isshifted into PARK (P).Mode 3: All doors unlock when the key is removedfrom the ignition.Mode 4: No automatic door unlock.The automatic door locks were pre-programmed at thefactory to unlock the driver's door once the transmissionis shifted to PARK (P). The following instructions detailhow to program your door locks differently than thefactory setting. Choose one of the four programmingoptions listed above before entering the program mode.
参考になったと評価
15人が参考になったと評価しています。
その他の取扱説明書
2198 view
450 view
639 view
387 view
856 view
もっと見る