MENTOR MENUETの取扱説明書・マニュアル [全34ページ 2.24MB]
2
9UKDEDK3.1 MENTOR 5, 6, 8the speakers are designed to stand on the loor. using spikes or rubber bumpers under the speakers, (see Figure 3 +4). Be careful not to over tighten the contra nuts. Spikes or rubber bumpers can improve the sound quality. You can try both to hear what gives the best sound quality in your setup. Please be aware, that spikes may damage the loor, if it is not protected.Note: On some loor surfaces and in some rooms, the use of spikes is a crucial aspect of obtaining the best result. the spikes included on MENtOR 8, 6 and 5, should be screwed in loosely in the threaded holes in the bottom of the speaker. Place the loudspeaker upright on its spikes on the loor, so that it stands steadily without rocking. tighten the nuts, so that the four spikes sit tightly. these assembly and setup steps ensure stable mechanical coupling to the surface beneath.3.2 MENTOR 2DALI recommends that you place your MENtOR 2 on a stand for the optimum sound experience. Alternatively, MENtOR 2 can be placed on a shelf. the enclosed rubber bumpers can be mounted under the speaker for stable and vibration-free positioning (see igure 4).3.3 MENTOR MENUET + MENTOR 1the speakers can be positioned on a stand/shelf or hung on the wall using an optional wall bracket(s). If positioned on a stand or shelf, the enclosed rubber bumpers can be placed under the speaker for stable and vibration-free positioning (see igure 4). For wall mounting you must use an optional wall bracket(s) (available at all DALI dealers). Before mounting the speakers to the wall, position the special bumpers, which are enclosed in the wall bracket packaging, on the rear edge of the speaker. these bumpers ensure the correct distance from the wall.3.4 MENTOR VOKALMENtOR VOKAL is the ultimate center channel and should be placed on a stand or a shelf. the enclosed rubber bumpers can be placed under the speaker for stable and vibration-free positioning (see igure 5).3.5 MENTOR LCRMENtOR LcR is suited for placement on a wall or lying on a shelf (as a center channel). For wall mounting, use the two integrated wall brackets on the rear side of the speaker. Fix two screws in the wall, a distance of 430 mm/16.9” apart, on which the speaker can hang. Position the screws above each other if the speaker is used as Left or Right speaker (vertically – see igure 6) or next to each other if the speaker is used as a center channel speaker (horizontally – see igure 7).If placed on a shelf/stand and used as a center channel, the enclosed rubber bumpers can be placed under the speaker for stable and vibration-free positioning (see igure 5).
