ルンバ577の取扱説明書・マニュアル [全36ページ 4.66MB]
00152.0210.v1.ALLRoomba.Manual.EN.pdf
http://www.irobot.com/.../00152.0210.v1.ALLRoomba.Manual.EN.pdf - 4.66MB
- キャッシュ
32987view
36page / 4.66MB
18 iRobot Roomba 500 Series Wireless Command Center (optional accessory for selected models)The Wireless Command Center lets you conveniently control Roomba’s functions. You can use it to turn Roomba on and off, schedule Roomba to clean, and steer Roomba around your room....Pairing Roomba with the Wireless Command CenterWireless Command Centers are set up to control only one Roomba. To pair a Wireless Command Center with a Roomba, you need four “AA” batteries (not included).Troubleshooting LightSPOTRoomba spirals approximately three feet in diameter and then spirals back to where it started, intensely cleaning a local area. CLEANRoomba automatically calculates the room size and adjusts its cleaning time appropriately. . . .Models 570-599Roomba attempts to dock on the Home Base, if present.Models 600+Roomba enters Max mode and cleans as long as the battery allows.Battery Indicator. . .1Make sure Roomba’s battery is fully charged.2Unplug the power supply or remove Roomba from its Home Base.3Install three “AA” batteries into the Command Center.4Hold down the left drive button while installing the fourth battery.5Continue holding the button for 3 seconds or until the days of the week lights lash in a sequence from right to left (Saturday to Sunday).6Install the battery door and place the Command Center on top of Roomba.7Press and hold the DAY and MINUTE buttons on the Command Center for 2 seconds. The lights on the Command Center will lash to indicate the pairing has completed, and Roomba will make a two-tone beep.8When the Command Center is powered on from now on, the lights will lash in sequence from left to right until Roomba is under control.
参考になったと評価
70人が参考になったと評価しています。
その他の取扱説明書
18536 view