2NF-01A (Powered Near Field Studio Monitor)CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).NO USER - SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPEN9. Heat - The appliance should be situated away from heat sourcessuch as radiators, heat registers, stoves, or other appliances(including amplifiers) that produce heat.10. Power Sources - The appliance should be connected to a powersupply only of the type described in the operating instructions oras marked on the appliance.11. Grounding or Polarization - The precautions that should be takenso that the grounding or polarization means of an appliance isnot defeated.12. Power Cord Protection - Power supply cords should be routedso that they are not likely to be walked on or pinched by itemsplaced upon or against them, paying particular attention to cordsat plugs, convenience receptacles, and the point where theyexit from the appliance.13. Cleaning - The appliance should be cleaned only asrecommended by the manufacturer.14. Nonuse Periods - The power cord of the appliance should beunplugged from the outlet when left unused for a long period oftime.15. Object and Liquid Entry - Care should be taken so that objectsdo not fall and liquids are not spilled into the enclosure throughopenings.16. Damage Requiring Service - The appliance should be servicedby qualified service personnel when:A. The power supply cord or the plug has been damaged; orB. Objects have fallen, or liquid has been spilled into the appliance; orC. The appliance has been exposed to rain; orD. The appliance does not appear to operate normally orexhibits a marked change in performance; orE. The appliance has been dropped, or the enclosure damaged.17. Servicing - The user should not attempt to service the appliancebeyond that described in the operating instructions.All other servicing should be referred to qualified servicepersonnel.The lightning flash with arrowhead symbol, within an equilateraltriangle, is intended to alert the user to the presence ofuninsulated "dangerous voltage" within the product's enclosurethat may be of sufficient magnitude to constitute a risk of electricshock to persons.The exclamation point within an equilateral triangle is intendedto alert the user to the presence of important operating andmaintenance (servicing) instructions in the literatureaccompanying the appliance.CAUTION:TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OFPLUG TO WIDE SLOT, FULLY INSERT.ATTENTION:POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRELA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNECORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND.An appliance and cart combination should be moved with care.Quick stops, excessive force, and uneven surfaces may causethe appliance and cart combination to overturn.7. Wall or Ceiling Mounting - The appliance should be mounted toa wall or ceiling only as recommended by the manufacturer.8. Ventilation - The appliance should be situated so that its locationor position dose not interfere with its proper ventilation.For example, the appliance should not be situated on a bed,sofa, rug, or similar surface that may block the ventilationopenings; or, placed in a built-in installation, such as a bookcaseor cabinet that may impede the flow of air through the ventilationopenings."WARNING""TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,DO NOT EXPOSE THIS APPLIANCE TO RAIN ORMOISTURE."SAFETY INSTRUCTIONS1. Read Instructions - All the safety and operating instructionsshould be read before the appliance is operated.2. Retain Instructions - The safety and operating instructionsshould be retained for future reference.3. Heed Warnings - All warnings on the appliance and in theoperating instructions should be adhered to.4. Follow Instructions - All operating and use instructions shouldbe followed.5. Water and Moisture - The appliance should not be used nearwater - for example, near a bathtub, washbowl, kitchen sink,laundry tub, in a wet basement, or near a swimming pool, andthe like.6. Carts and Stands - The appliance should be used only with acart or stand that is recommended by the manufacturer.
