Wireless Optical Desktopの取扱説明書・マニュアル [全42ページ 1.71MB]
122544.pdf
gizport - 2013-08-14
http://153.127.246.254/.../122544.pdf - 1.71MB
- キャッシュ
10487view
42page / 1.71MB
2 Connect the Receiver to Your ComputerWith your computer turned on, plug the rectangular USB connector into your computer’s rectangular USB port.3 Position the Receiver, Keyboard, and Mouse1 Position the receiver at least 8 inches (20 cm) away from your computer monitor, computer case, and any other items that might cause interference (such as metal filing cabinets, desktop fans, or fluorescent lights).2 Position the keyboard and mouse no less than 8 inches (20 cm) from the receiver but no more than 6 feet (1.8 m) from the receiver. This distance varies depending on nearby items causing interference and other factors.About the Receiver LightThe receiver light indicates the reconnection mode: when you press the receiver button, the light blinks. If the mouse or keyboard is not working properly, try reconnecting the device as described in the following section. 4 Test the Keyboard and MouseTry using the keyboard and mouse to make sure that they are working. Tip To test the keyboard, press the Windows logo key ( ). This opens the Windows Start menu.If either device does not work as expected, make sure that the following procedures were completed as specified earlier in these instructions:● New batteries are inserted and positioned correctly in both the keyboard and the mouse.● The keyboard, mouse, and receiver are correctly positioned and there are no nearby items that might cause interference.● The receiver is correctly connected to the computer.To reconnect the mouse to the receiver ● Press the Connect button on the receiver (located on top of the receiver next to the receiver light), and then immediately press the Connect button on the bottom of the mouse. Using the tip of a pen may make it easier to press the button.USB Connector2X118135401mnl.indb 2 1/19/2006 12:12:12 PM
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
14335 view
28796 view
1532 view