SoundSticks IIIの取扱説明書・マニュアル [全47ページ 6.21MB]
SOUNDSTICKSIII_OM_EN.pdf
gizport - 2013-08-14
http://www.harmankardon.com/.../SOUNDSTICKSIII_OM_EN.pdf - 6.21MB
- キャッシュ
21511view
47page / 6.21MB
5Step 5. Plug power cord into power adapter.Step 6. Plug power adapter into subwoofer.Step 7. Plug power cord into wall receptacle.Step 8. Push power ON/OFF button. Unit is on when LED is lit. Push the subwoofer volume knob/power ON/OFF button. Unit is on when the LED is lit. Use the subwoofer volume knob to balance the subwoofer’s volume with that of the satellites.Step 9. Adjust volume level by touching + or – button. Touching both the + and – buttons mutes the audio. When muted, touching either button unmutes the audio.www.harmankardon.comSymptom Possible problem SolutionNo sound from subwoofer, only satellites.No sound from satellites, only subwoofer.High frequencies sound dull.Subwoofer volume control set at minimum.Satellites not connected to subwoofer.Satellites not positioned properly.Rotate subwoofer volume control clockwise until relative volume level is appropriate.Check connection of satellites to subwoofer. Position and tilt (angle) loudspeakers toward listener. The sound from the satellites is very directional due to the four -element linear array design.This product is intended to be supplied by a listed direct plug-in power unit marked “Class 2” and output rated 16V DC minimum 1.5 A.Easy Setup Guide0211CSK - HK Soundsticks III v2.indd 5 21/04/10 15:01:02
参考になったと評価
23人が参考になったと評価しています。