Vostro 1320の取扱説明書・マニュアル [全45ページ 1.11MB]
inspiron-1320_Service%20Manual_en-us.pdf
gizport - 2013-10-28
ftp://ftp.dell.com/.../inspiron-1320_Service%20Manual_en-us.pdf - 1.11MB
- キャッシュ
10580view
45page / 1.11MB
4. Lift the processor module from the ZIF socket. Replacing the ProcessorNOTE: If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive anew thermal pad along with documentation to illustrate proper installation.1. Follow the procedures in Before You Begin.2. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than theothers, the module is not seated properly. CAUTION: To avoid damage to the processor, hold the screwdriver perpendicular to the processor when turning the cam screw.3. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.4. Replace the processor heat sink assembly (see Replacing the Processor Heat Sink Assembly). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.Back to Contents Page
参考になったと評価
9人が参考になったと評価しています。
その他の取扱説明書
761 view