Vostro 1320の取扱説明書・マニュアル [全45ページ 1.11MB]
inspiron-1320_Service%20Manual_en-us.pdf
gizport - 2013-10-28
ftp://ftp.dell.com/.../inspiron-1320_Service%20Manual_en-us.pdf - 1.11MB
- キャッシュ
11205view
45page / 1.11MB
Back to Contents Page Processor Heat Sink AssemblyDell™ Inspiron™ 1320 Service Manual Removing the Processor Heat Sink Assembly Replacing the Processor Heat Sink AssemblyWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: If you remove the processor heat sink assembly from the computer when the heat sink is hot, do not touch the metal housing of theheat sink. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer). CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer. Removing the Processor Heat Sink Assembly1. Follow the instructions in Before You Begin.2. Follow the procedures from step 2 to step 18 in Removing the System Board.3.1 In sequential order (indicated on the processor heat sink), loosen the four captive screws that secure the processor heat sink assembly to the systemboard.processor heat sink assembly4.2captive screws (4) Lift the processor heat sink assembly off the system board. Replacing the Processor Heat Sink AssemblyNOTE: This procedure assumes that you have already removed the processor heat sink assembly and are ready to replace it.NOTE: The original thermal pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink isreplaced, use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.NOTE: This procedure assumes that you have already removed the processor heat sink assembly and are ready to replace it.1. Place the processor heat sink assembly on the system board.2. Align the four captive screws on the processor heat sink assembly with the screw holes on the system board and tighten the screws in ascending order.3. Follow the procedures from step 3 to step 17 in Replacing the System Board.
参考になったと評価
9人が参考になったと評価しています。
その他の取扱説明書
787 view