Inspiron 1525の取扱説明書・マニュアル [全51ページ 1.51MB]
1
Back to Contents Page Before You BeginDell™ Inspiron™ 1525/1526 Service Manual Recommended Tools Before Working Inside Your ComputerThis document provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that:l You have performed the steps in Before Working Inside Your Computer.l You have read the safety information in your Dell Product Information Guide.l When replacing a component, you have already removed the original, if installed.NOTE: The color of your system and certain system components may appear differently than shown in this document. Recommended ToolsThe procedures in this document may require the following tools:l Small flat-blade screwdriverl Phillips screwdriverl Small plastic scribel Flash BIOS update (see the Dell Support website at support.dell.com) Before Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety. CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is notcovered by your warranty.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, suchas a connector on the back of the computer.NOTICE: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metalmounting bracket. Hold a component such as a processor by its edges, not by its pins.NOTICE: When disconnecting a cable, pull on the cable's connector or on its strain-relief loop, not on the cable itself. For cable connectors with lockingtabs, press inward on the locking tabs to release the connector. When connecting a cable, ensure that the connectors are correctly oriented andaligned to avoid damage to the connector and/or the connector's pins.1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched. 2.Click Start, click the arrowicon, and then click Shut Down to turn off your computer.NOTE: Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the operating system,press and hold the power button for 4 seconds.3. Disconnect your computer and all attached devices from their electrical outlets.NOTICE: To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network wall jack.4.5. Disconnect any telephone or network cables from the computer. Remove any installed cards from the ExpressCard slot (see Removing an ExpressCard or Blank) and the 8-in-1 memory card reader (see Removing aMemory Card or Blank).NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you service the computer.NOTE: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for other Dellcomputers.6. Turn the computer over.
