Latitude D630の取扱説明書・マニュアル [全114ページ 4.35MB]
latitude-d630_reference%20guide_ja-jp.pdf
gizport - 2013-08-19
ftp://ftp.dell.com/.../latitude-d630_reference%20guide_ja-jp.pdf - 4.35MB
- キャッシュ
19268view
114page / 4.35MB
Quick Reference Guide 19Starting the Dell Diagnostics From Your Hard DriveThe Dell Diagnostics is located on a hidden diagnostic utility partition on your hard drive. NOTE: If your computer cannot display a screen image, contact Dell (see "Contacting Dell" in your User's Guide).1 Shut down the computer. 2 If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.3 Connect the computer to an electrical outlet.4 Diagnostics can be invoked in one of two ways:a Turn on the computer. When the DELLTM logo appears, press <F12> immediately. Select Diagnostics from the boot menu and press <Enter>. NOTE: If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft(R) Windows(R) desktop. Then shut down y our computer and try again.bPress and hold the <Fn> key while powering the computer on. NOTE: If you see a message stating that no diagnostics utility partitio n has been found, run the Dell Diagnostics from the Drivers and Utilities media.The computer runs the Pre-boot System Assessment, a series of initial tests of your system board, keyboard, hard drive, and display. During the assessment, answer any questions that appear. If a failure is detected, the computer stops and beeps. To stop the assessment and restart the computer, press <Esc>; to continue to the next test, press <y>; to retest the component that failed, press <r>. If failures are detected during the Pre-boot Sy stem Assessment, write down the error code(s) and contact Dell (see "Contacting Dell" in your User's Guide ). If the Pre-boot System Assessment completes successfully, you receive the message Booting Dell Diagnostic Utility Partition . Press any key to continue.5 Press any key to start the Dell Diagnostics from the diagnostics ut ility partition on your hard drive.Starting the Dell Diagnostics From the Drivers and Utilities Media1 Insert the Drivers and Utilities media.2 Shut down and restart the computer.When the DELL logo appears, press <F12> immediately.If you wait too long and the Windows logo appear s, continue to wait until you see the Windows desktop. Then shut down yo ur computer and try again. NOTE: The next steps change the boot seq uence for one time only . On the next start-up, the computer boots according to the devices specifie d in the system setup program.
参考になったと評価
9人が参考になったと評価しています。
その他の取扱説明書
737 view
483 view
249 view
316 view
430 view
もっと見る