1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. ノートパソコン >
6. XPS M1210 の使い方、故障・トラブル対処法 >
7. XPS M1210 の取扱説明書・マニュアル

XPS M1210の取扱説明書・マニュアル [全44ページ 1.63MB]

 Replacing the Processor ModuleNOTICE: Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in the ZIFsocket does not require force.NOTICE: A processor module that is not properly seated can result in an intermittent connection or permanent damage to the processor and ZIFsocket.1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, and insert the processor module.NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.NOTICE: You must position the processor module correctly in the ZIF socket to avoid permanent damage to the module and the socket.When the processor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than theothers, the module is not seated correctly.2. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.NOTE: When you replace the thermal-cooling assembly, be sure to place a new thermal pad on the thermal-cooling assembly such that the pad fitsbetween the assembly and the processor. You can place the new thermal pad directly on any existing thermal pad already installed on the thermalcooling assembly. It is not necessary to remove an existing pad or to clean the surface.NOTE: When replacing the thermal-cooling assembly, hold up the mylar flap on the assembly so that the flap rests on top of the fan when the thermalcooling assembly is in place.3. Replace the thermal-cooling assembly (see Replacing the Thermal-Cooling Assembly).4. Replace in reverse order the remaining components that you removed in Removing the Processor Module, beginning with step 5.Back to Contents Page 

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.