Vostro 1510の取扱説明書・マニュアル [全62ページ 1.36MB]
vostro-1510_service%20manual_en-us.pdf
gizport - 2013-08-21
ftp://ftp.dell.com/.../vostro-1510_service%20manual_en-us.pdf - 1.36MB
- キャッシュ
17999view
62page / 1.36MB
NOTICE: Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in theZIF socket does not require force. A processor module that is not properly seated can result in an intermittent connection or permanent damageto the microprocessor and ZIF socket.NOTE: If you are installing a new processor, you will receive a new thermal-cooling assembly which will include an affixed thermal pad, or you willreceive a new thermal pad along with a tech sheet to illustrate proper installation.This procedure assumes that you have completed the removal procedure Removing the Processor Module.1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than theothers, the module is not seated properly.1 ZIF-socket cam screw 2 ZIF socket3 pin-1 corner NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.2. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.3. Replace the processor thermal-cooling assembly (see Replacing the Processor Thermal-Cooling Assembly).4. Replace the fan (see Replacing the Fan).5. Replace the memory cover and tighten the screws.Back to Contents Page
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
27718 view
861 view
1562 view
729 view
1112 view