Vostro 2420の取扱説明書・マニュアル [全148ページ 4.05MB]
poweredge-2420_Setup%20Guide_ja-jp.pdf
gizport - 2013-09-09
ftp://ftp.dell.com/.../poweredge-2420_Setup%20Guide_ja-jp.pdf - 4.05MB
- キャッシュ
17702view
148page / 4.05MB
18 Installation Guidec Push the screwdriver into the notch until it stops and turn it counter-clockwise.d Lift up on the badge and pull it off the door.e Rotate the badge 180 degrees so that it will read correctly when reinstalled.f Locate the fourth horizontal bar fr om the top of the door and slide the badge hooks over it, aligning th e center tabs on the badge with the vertical bar on the door.g Push up on the badge retention clips until they are closed and the badge is secure.Securing the Rack Leveling Feet WARNING: Read all statements below b efore you adjust the leveling feet.Your rack includes four leveling feet, which are mounted on the corners of the rack. The leveling feet are designed to align the rack in an upright, level position when the rack is situated on a slightly uneven floor surface. Before you install your systems in the rack, de ploy and adjust the leveling feet. When you level your rack, follow these guidelines. WARNING: When you adjust the le veling feet, ensure that the casters on each corner of the rack do not rise mo re than 9.5 mm (3/8 inch) above the floor. If you exceed 9.5 mm of clearance between the floor and the ca sters as you adjust the leveling feet, slowly retract the leveling feet, and then move the rack to another location that requires minimal adjustments to the leveling feet. WARNING: Adjust the leveling feet until each leveling foot rests firmly on the floor. Proper contact with the floor ensures that each lev eling foot is supporting the weight of the rack and prevents the rack from swaying in any direction. If the leveling feet are not all in firm contact with the floor, the rack can become unstable and tip over. WARNING: Do not attempt to move yo ur rack with the leveling feet deployed. Always retract the leveling feet before mov ing the rack. Having the leveling feet deployed when you move the ra ck may cause the rack to tip over. WARNING: Always level the rack and install the stabilizing feet before you install your systems. A full y loaded rack may tip over if your rack is resting on an uneven floor surface and the leveling and stabilizing feet ar e not supporting the weight of the rack. NOTE: If the rack is not leveled properly, you might not be able to install the stabilizer feet, which are necessary to prevent the rack from tipping over.
参考になったと評価
4人が参考になったと評価しています。
その他の取扱説明書
219 view
341 view
176 view
234 view
159 view
もっと見る