IQX 635の取扱説明書・マニュアル [全32ページ 0.30MB]
123146.pdf
http://153.127.246.254/.../123146.pdf - 0.30MB
- キャッシュ
5471view
32page / 0.30MB
with the same settings (power levels,cooking time) as before the pause.The second button must be pressed within10 seconds, otherwise the stove willswitch off. If cooking is not resumed within10 minutes of being paused, the stove willagain switch off.Function for keeping a pan hot(models チc622)Using this function, it is possible to keepfood hot in a pan placed on the cookingarea.1There is a pan on one of the heating ele -ments at a previously selected cookingtemperature.2It is necessary to touch sensor (4),after which the symbol will appear inthe indicator. This is a level between the0and 1.To disconnect this function, just touch sen -sor (4) and change to level 0. Thisfunction will only work for a maximum of120 minutes, after which the hob will dis -connect.Timer functionThis function aids the cooking process, asit is not necessary to be watching: You canset a hob timer and it will turn off automa -tically once the selected time has elapsed.There are 4 lights surrounding the timerdisplay, showing which of the hobs has atimer set. For example, if you set a timerfor the upper left hob, the light on theupper left of the timer display will turn on.If there are no timers set on any of thehobs (no hob timer light (10) on), the timercan be used as a countdown timer (seesection "Countdown Timer").On these models you can set the count -down timer and the hob timer from 1 to 99minutes. All of the hobs can be program -med independently and operate simulta -neously.Timing a hotplate1The hotplate to be timed has to be selec -ted. The corresponding decimal point(11) must be lit.2Select a power level of between 1and 9using the or sensors (5/4).3Touch the clock sensor (7). The deci -mal point (11) of the time display (8) willcome on4Touch the clock sensor sensor (7)until the time display of the correspon -ding hotplate (10) flash on.5Now set a cooking time, between 1and99minutes, using the sensors or (5/4). With the first one you will start with1, and with the second with 30. Touchingboth at the same time the value willcome back to 00.The clock will begin to control the timeautomatically. The control display (10)corresponding to the timed area willremain lit up. If you want to set a time foranother hotplate, you have to repeat the 4and 5 steps. When the chosen time elapses, the timedarea will switch off and the clock will give aseries of beeps for several seconds. Thetime display will show 00and this will flashon and off, together with the pilot light ofthe hotplate that has disconnected.If the hotplate that has been switched off isGB23
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
7449 view
4649 view