OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22169view
174page / 1.59MB
Microprocessor: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/process.htm [2/21/2013 11:47:20 AM]Back to Contents PageMicroprocessor: DellTM OptiPlexTM GX1 Small-Form-Factor SystemUser's GuideTo upgrade an existing microprocessor, perform the following steps.NOTE: Dell recommends that only a technically knowledgeable person perform this procedure.CAUTION: Before you remove the computer cover, see " Safety First-For You and YourComputer ."1. Remove the computer cover.2. Disconnect the microprocessor fan cable from the connector (labeled "FAN") on the system board.3. Gently pull out the guide-bracket assembly latches, grasp the microprocessor/heat sink assemblyfirmly, and pull straight up to remove it from the guide bracket assembly.You must use up to 15 pounds of force to disengage the microprocessor from the connector. Do notrock the microprocessor while removing it.4. Slide the microprocessor/heat sink assembly into the guide bracket assembly, with the heat sinktoward the right side of the computer, and firmly seat the microprocessor/heat sink assembly.You must use up to 25 pounds of force to seat the microprocessor. Do not rock themicroprocessor/heat sink assembly while inserting it into the connector.Figure 1. Microprocessor Removal1Microprocessor fan2Guide bracket assembly3Guide bracket assembly latch4Microprocessor/heat sink assembly
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
237 view
184 view
251 view