OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22573view
174page / 1.59MB
Messages and Codes: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/messages.htm [2/21/2013 11:47:24 AM]Back to Contents PageMessages and Codes: DellTM OptiPlexTM GX1 Small-Form-FactorSystem User's GuideOverview Warning MessagesSystem Messages Diagnostics MessagesSystem Beep CodesOverviewYour application programs, operating system, and the computer itself are capable of identifying problemsand alerting you to them. When a problem occurs, a message may appear on your monitor screen or a beepcode may sound. See "System Messages" or "System Beep Codes " for information about each message orbeep code.System MessagesIf you receive a system message, see Table 1 for suggestions on resolving any problems indicated by themessage. The system messages are listed alphabetically.NOTE: If the system message you received is not listed in the table, check the documentation for theapplication program that you were running at the time the message appeared and/or the operatingsystem documentation for an explanation of the message and a recommended action.Table 1. System MessagesMessage Cause ActionAddress mark not foundThe basic input/outputsystem (BIOS) found afaulty disk sector or couldnot find a particular disksector.See "Troubleshooting Drives."Attachment failed to respondThe diskette drive orhard-disk drive controllercannot send data to theassociated drive.See "Troubleshooting Drives."Bad command or file nameThe command youentered does not exist oris not in the pathnameyou specified.Make sure you have spelled thecommand correctly, placedspaces in the proper location,and used the correct pathname.
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
249 view
189 view
258 view