1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

Dell Diagnostics: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/diag.htm [2/21/2013 11:47:14 AM]Similar to the Read Test, but no data is transferred from the drive to the system.Write TestPositions the read/write heads at each block of the drive and verifies that all tracks on the drive can bewritten to correctly.SMART TestChecks to see if a hard-disk drive's internal error thresholds have been exceeded, which might predictimpending hard-disk drive failure. If any thresholds have been exceeded, the test fails.CD-ROM Audio TestAttempts to play an audio track from a CD in a CD-ROM drive. If the system does not have speakersand an integrated audio controller or sound card, you must connect headphones to the CD-ROMheadphone jack to verify whether the test completes successfully.Media Eject TestAttempts to electronically eject media from a removable media drive. If the drive does not supportelectronic media ejection, the test is meaningless.Tape Retension TestPerforms a tape retension operation on a tape drive with a tape cartridge installed. Tape drive errorsare sometimes due to a cartridge that needs to be retensioned.Why Run an IDE (ATA/ATAPI) Devices Test?NOTE: If you check your hard-disk drive to determine the amount of available space, your operatingsystem will probably report problem areas. Problem areas on hard-disk drives are common becausemost hard-disk drives have a small amount of space that is not usable. The hard-disk drive keeps arecord of this space so that your computer will not attempt to use it. Identification of unusable diskspace, unless it is an unusually large amount (over five percent of the possible total), should not beregarded as a cause for testing the hard-disk drive.These are the most common symptoms that might prompt you to test an IDE drive:The drive fails during the boot routine.Seek errors are reported by the operating system or application programs.An error message appears on the screen stating that the computer cannot read from or write to thedrive.Data on the drive is corrupted or lost; this problem may be intermittent. Once saved by a program, filescannot be properly recalled.Serial/Infrared Ports Test GroupThe subtests in the Serial/Infrared Ports Test Group check the computer's interface with external devices,

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.