1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

External Components: Dell GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/external.htm [2/21/2013 11:47:18 AM]procedures in "Troubleshooting Expansion Cards " to verify that the card is configured and installed correctly.If a system error message indicates a port problem or if equipment connected to a port seems to performincorrectly or not at all, the source of the problem may be any of the following:A faulty connection between the I/O port and the peripheral deviceA faulty cable between the I/O port and the peripheral deviceA faulty peripheral deviceIncorrect settings in the System Setup programIncorrect settings in the system's configuration filesFaulty I/O port logic on the system boardNOTE: With certain modems installed, the Serial/Infrared Port Test Group subtests may failbecause the modem appears to the diagnostics as a serial port, but it cannot be tested as a serialport. If you have a modem installed and you experience a serial port test failure, remove the modemand run the diagnostic tests again.Troubleshooting Basic I/O FunctionsIf a system error message indicates an I/O port problem or the device connected to the port does not functionproperly, follow these steps in the order indicated until the problem is resolved:1. Enter the System Setup program and verify that the settings for the Serial Port 1, Serial Port 2 , andParallel Port options are set to Auto .2. Insert the Dell ResourceCD into the appropriate drive, reboot the system, and run the Serial/InfraredPorts Test Group and/or the Parallel Ports Test Group in the Dell Diagnostics .If any of the tests fail, the system board may be faulty. See " Getting Help" for instructions on obtainingtechnical assistance.If the problem persists, go to " Troubleshooting a Parallel Printer" or " Troubleshooting a Serial I/ODevice ," depending on which device appears to be malfunctioning.Troubleshooting a Parallel PrinterIf the information in " Troubleshooting Basic I/O Functions " indicates that the problem is with a parallelprinter, perform the following steps in the order indicated until the problem is resolved:1. Reinstall the printer device driver.See the documentation for the printer and for your operating system for instructions on reinstalling theprinter driver.2. Turn off the parallel printer and computer, replace the parallel printer interface cable with a known

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.