OptiPlex SX280の取扱説明書・マニュアル [全74ページ 4.59MB]
optiplex-sx280_setup%20guide_ja-jp.pdf
ftp://ftp.dell.com/.../optiplex-sx280_setup%20guide_ja-jp.pdf - 4.59MB
- キャッシュ
10147view
74page / 4.59MB
Quick Reference Guide 19Dell Diagnostics CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide .When to Use the Dell DiagnosticsIf you experience a problem with your comput er, perform the checks in "Setting Up Your Computer" on page 10 and run the Dell Diagnosti cs before you contact Dell for technical assistance. NOTICE: The Dell Diagnostics work s only on DellTM computers.Enter system setup, review your computer's config uration information, and ensure that the device you want to test is displayed in system setup and is active. For information on system setup, see your online User's Guide .Start the Dell Diagnostics from either your hard drive (see "Starting the Dell Diagnostics From Your Hard Drive" on page 19) or from the Drivers and Utilities CD (also known as the ResourceCD -see "Starting the Dell Diagnostics From the Drivers and Utilities CD" on page 19).Starting the Dell Diagnostics From Your Hard Drive1 Turn on (or restart) your computer.2 When the DELLTM logo appear s, press <F12> immediately. NOTE: If you see a message stating that no diagnostics utility partition has been found, see "Starting the Dell Diagnostics From the Drivers and Utilities CD" on page 19.If you wait too long and the operating system lo go appears, continue to wait until you see the Microsoft(R) Windows(R) desktop. Then shut down yo ur computer and try again. For information on shutting down your computer, see your online User's Guide .3 When the boot device list appears, highlight Boot to Utility Partition and press <Enter>.4 When the Dell Diagnostics Main Menu appears, select the test you want to run (see page 20).Starting the Dell Diagnostics From the Drivers and Utilities CD1 Insert the Drivers and Utilities CD.2 Shut down and restart the computer. When the DELL logo appears, press <F12> immediately.If you wait too long and the Windows logo a ppears, continue to wait until you see the Windows desktop. Then shut down your computer and try again. NOTE: The next steps change the boot sequence for one time only. On the next start-up, the computer boots according to the devices specified in system setup.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
205 view