Gizport

LC-26BD1の取扱説明書・マニュアル [全12ページ 1.40MB]

-1
lc26bd1-2_qsg.pdf
Gizbot 2013-09-01
http://www.sharp.co.jp/.../lc26bd1-2_qsg.pdf - 1.40MB - キャッシュ
554view
12page / 1.40MB
Share (facebook)
6 / 12 ページ
 
6 / 12 ページ
3 件の検索結果
ファイルを開く
現在のページURL
213Quick Start GuideQuick Start GuideBasic Operations Part Names - Remote Control Unit This TV set communicates with digital TV stations even when it is in the standby mode (with the power indicator lit red). When you press the active/standby (電源) button on the remote control to turn off the TV, it may take a while before the power is actually turned off. (During this time, the system is storing the internal data to its memory.)Basic OperationsShown on this and the next three pages are the basic operations for enjoying TV and video programs.Turning the power on選局入力切換 電源 (押・入-切) 音量・ The power indicator lights up in green indicating the TV set is now in the active mode.・ The power indicator is lit red when the TV set is in the standby mode.Active/standby button▼Remote control❶ Press the main power on/off (電源 (押・入-切) ) switch in the control section of the main unit to turn the main power on.❷ After the main power is turned on, press the active/standby (電源) button on the remote control to engage the TV set in the active or standby mode.▼Control section of the main unit▼Indicators on the main unitPower indicator・ Green⋯ The TV set is in the active mode.・ Red⋯⋯ The TV set is in the standby mode.Main power on/off switchヘッドホン 予約 明るさセンサー 電源NoteoteNote

参考になったと評価
  42人が参考になったと評価しています。

このマニュアルの目次

  • 1 .
    208Quick Start GuidePart ...
    208Quick Start GuidePart Names - Main UnitLC-26BD1 LC-26BD2LC-26BD1 LC-26BD2292964B-CAS card slotSpeaker sectionPower indicator ⋯⋯⋯⋯⋯⋯⋯⋯⋯Remote sensor window ⋯⋯⋯⋯⋯ When using the remote control, point its head toward this window.Ambient illuminationse...
  • 2 .
    209Quick Start GuidePart ...
    209Quick Start GuidePart Names - Main Unit193193154126146120・148114・122743433353333112130118134182Digital audio output jack (optical)TV module reset buttonAV in 6 (audio)Rear viewVCR controller connectorBS/CS 110 antenna input terminalLAN jacki.LINK (TS) j...
  • 3 .
    210Quick Start GuidePart ...
    210Quick Start GuidePart Names - Remote Control UnitCATV⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯Cover closedDisplay⋯⋯⋯⋯⋯⋯⋯⋯⋯Press to display or turn off the channel call, etc.Active/Standby⋯⋯⋯⋯⋯⋯Press to engage the TV set in the active or standby mode.When selecting a CATV channel by ...
  • 4 .
    211Quick Start GuidePart ...
    211Quick Start GuidePart Names - Remote Control UnitDigital channel register ⋯⋯Press to display or turn off the channel register/registered channel table screen.86Freeze⋯⋯⋯⋯⋯⋯⋯⋯⋯Press to freeze the picture. 174Picture select⋯⋯⋯⋯⋯⋯Press to select the desire...
  • 5 .
    212Quick Start GuideOpen ...
    212Quick Start GuideOpen the battery cover.Insert the supplied two AAA batteries, and close the cover.Gently holding down the -marked area, slide the cover in the direction of the arrow.Make sure that the terminals match the and indications in ...
  • 6 .
    213Quick Start GuideQuick...
    213Quick Start GuideQuick Start GuideBasic Operations Part Names - Remote Control Unit This TV set communicates with digital TV stations even when it is in the standby mode (with the power indicator lit red). When you press the active/standby (電源) button o...
  • 7 .
    214Quick Start GuideRemot...
    214Quick Start GuideRemote controlNetwork select buttonsSee pages 217 through 219, 82 through 110 for digital broadcast-related operations.Power on/off, channel selection, volume controlSelect the desired network.Turn on the TV.Power on ............(Active...
  • 8 .
    215Quick Start GuideBasic...
    215Quick Start GuideBasic Operations②①On-screen displays, CATV, input selection, etc.Press to display or turn off the channel sign. Press to display the current channel sign. Press again to turn it off.Channel sign examplesTerrestrial analog TVBS digital...
  • 9 .
    216Quick Start Guide① Pre...
    216Quick Start Guide① Press (menu) to display the menu screen.② Press or to select “本体設定”(Setup).12Basic Operations■ Using the menu screen, you can switch the on-screen display language to English.Press or to select “Language (言語設定)”, then press ...
  • 10 .
    217Quick Start GuideQuick...
    217Quick Start GuideQuick Start GuideEnjoying Digital BroadcastsBasic OperationsSelect the desired digital broadcast networkThe TV set incorporates a digital tuner that allows you to receive three digital broadcast networks -- terrestrial digital, BS, CS. ...
  • 11 .
    218Quick Start GuideEnjoy...
    218Quick Start GuideEnjoying Digital BroadcastsCS (CS 110 digital) channelsChannel selectbutton100001----TVChannel number------RadioChannel number------DataChannel numberChannel selectbutton------TVChannel number------RadioChannel number------DataChannel n...
  • 12 .
    219Quick Start GuideEnjoy...
    219Quick Start GuideEnjoying Digital BroadcastsCover open● Multiple pictures Press (picture select) under the cover until the desired picture is selected. (This feature is only available when the current program has multiple pictures.)● Multiple...

この取扱説明書が関連付けられている製品

AQUOS LC-26BD2の取扱説明書・マニュアル
AQUOS LC-26BD2の取扱説明書・マニュアル